Journal Entry #6: 3D Modeling with TinkerCAD

Object #1: PVC Pipe

My first attempt at the PVC Pipe wasn't hollowed out enough, so I recreated it and got it right on the second try... 

Object #2: Hollow Plastic Pink Egg

The hollow plastic pink egg was pretty easy...

Object #3: Floppy Disk (i.e., "Save Icon" 😜)

The floppy disk was a bit more complicated than the first two objects, but I was able to figure it all out...

Object #4: Evil Spoon from Hell (i.e., "Devil's Spawn Spoon")

It speaks for itself...

Object #5: Flask

The flask was very challenging. However, after many attempts and lots of modifying and correcting, I believe I was able to get the basic idea of the flask...

Object #6: Bowler Hat

The bowler hat was challenging, but I was able to get it all figured out. I was able to get it hollowed out and get the curvature of the brim. I took three screenshots to thoroughly demonstrate both the hollowness and the curvature...

Object #7: Aviator Glasses

The aviator glasses were challenging. I didn't have too much trouble making the lenses and shaping them or setting them to transparent. I also didn't have too much trouble making the frames around the lenses or the brow bar or nose bridge. The nose pads were not difficult. The hardest part was making the temples in such a way that they curve over the ears. I achieved this using multiple shapes and would have liked it to have bended a little smoother, but I was able to get the basic shape. I believe these look like aviator glasses...